raised panel fridge cap

Greg McCorkill · Post by **Greg McCorkill** » Sun, Jan 28 2007, 12:28PM

how do i add a raised panel end cap next to the refridgerater?

Rick Palechuk · Post by **Rick Palechuk** » Sun, Jan 28 2007, 1:09PM

Hey Greg, in \"place items\" you can add a door as an end panel.

Michael Yeargain · Post by **Michael Yeargain** » Sun, Jan 28 2007, 11:54PM

While in the place item mode also you can double click on the cabinet and s,j,c (adjust cabinet end) dialog will pop up and allow the addition of a door with insets if needed. Negative insets (as always) will adjust outward from the cabinet.

Although adding them as display items will probably give you the best results. The software does not support multipanel doors yet.

Rick Palechuk · Post by **Rick Palechuk** » Mon, Jan 29 2007, 12:40AM

But for appearances that can be dealt with by merging two doors.

Kerry Fullington · Post by **Kerry Fullington** » Mon, Jan 29 2007, 7:27AM

Here is a link to another thread on this subject
Paneled Ends
Kerry

Thermwood / eCabinet Systems

raised panel fridge cap

raised panel fridge cap