part editor alignment

FredHirsch · Post by **FredHirsch** » Wed, Jan 31 2007, 1:00PM

Is there an easy technique to aligning a geometry to the center of a square or rectangular panel? If I put a 2\" diameter circle on a square back panel, is there quick way to align to center, or do I need to figure the width height of the back panel and change the object move and move with the keyboard arrows?
Thanks,
Fred

DanEpps · Post by **DanEpps** » Wed, Jan 31 2007, 1:51PM

Fred

You can use equations when entering the x,y coordinates. Just use the width divided by 2 and length divided by 2.

For example to center a circle on a 24\" x 24\" square, enter (24/2),(24/2) in the x,y coordintate box.

FredHirsch · Post by **FredHirsch** » Thu, Feb 01 2007, 12:58PM

Thanks Dan.. just looking for an easier way

Fred