part editor alignment

Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal

Post Reply
FredHirsch
Senior Member
Posts: 167
Joined: Tue, Oct 03 2006, 6:51PM
Location: Phoenix, AZ
Contact:
Contact FredHirsch

part editor alignment

Post by FredHirsch »

Is there an easy technique to aligning a geometry to the center of a square or rectangular panel? If I put a 2\" diameter circle on a square back panel, is there quick way to align to center, or do I need to figure the width height of the back panel and change the object move and move with the keyboard arrows?
Thanks,
Fred
Fred Hirsch
Top
User avatar
DanEpps
Wizard Member
Posts: 5852
Joined: Thu, Jul 28 2005, 10:18AM
Company Name: Dan Epps
Country: UNITED STATES
Location: Rocky Face GA

Post by DanEpps »

Fred

You can use equations when entering the x,y coordinates. Just use the width divided by 2 and length divided by 2.

For example to center a circle on a 24\" x 24\" square, enter (24/2),(24/2) in the x,y coordintate box.
Top
FredHirsch
Senior Member
Posts: 167
Joined: Tue, Oct 03 2006, 6:51PM
Location: Phoenix, AZ
Contact:
Contact FredHirsch

Post by FredHirsch »

Thanks Dan.. just looking for an easier way :oops:
Fred
Fred Hirsch
Top
Post Reply

Return to “eCabinet Systems Software”