25mm to 18mm Why?

Thom Davies · Post by **Thom Davies** » Mon, Jan 29 2007, 8:17PM

Hey hows it all going?

Something werid is happening on ecab. i make a 25mm thick board and use it on a cabinet then when i load it up again or take it 2 batch cabinets its tells me i have change it to 18mm. what the???

Is this a bug or some thing?

Thanks

Thom Davies

Walker T Scott · Post by **Walker T Scott** » Tue, Jan 30 2007, 7:41AM

Thom,

Im not seeing this could you post a cabinet with a board made with the 25mm thick material.

Thanks
Walker

Todd Miller · Post by **Todd Miller** » Tue, Jan 30 2007, 8:43AM

Thom,
Make sure you are creating \"sheet stock\" @ 25mm, and not \"board stock\" @ 25 mm.

Thom Davies · Post by **Thom Davies** » Tue, Jan 30 2007, 7:06PM

Hey Guys here is a cabinet made in 25mm.

Todd yes i did make it in sheet stock not board stock.

Thanks

Thom Davies

Thom Davies · Post by **Thom Davies** » Tue, Jan 30 2007, 7:08PM

Hey Guys here is a cabinet made in 25mm.

Todd yes i did make it in sheet stock not board stock.

Thanks

Thom Davies

Walker T Scott · Post by **Walker T Scott** » Wed, Jan 31 2007, 8:11AM

Thom,

Im not getting what you are seeing but, after adding the cabinet’s material to my database Im seeing a duplicate sheet stock material of the “25mm to 18mm” in the edge banding material. This may be causing the problem check and see if this is happing to you, If so try deleting it and let me know if this helps or not.

Walker

Walker T Scott · Post by **Walker T Scott** » Tue, Feb 06 2007, 8:34AM

Thom,

I have had no luck reproducing what you are experiencing. Other than some times a duplicate sheet stock material shows up in board stock, but this isn’t consistent for me. Im made notes and ill be watching for ether gremlin

. Sorry I couldn’t help resolve your issue at this time. If you experience this again let me know.

Walker