disk will not load

Patrick Koontz · Post by **Patrick Koontz** » Fri, Feb 16 2007, 9:39AM

Hi. My computer crashed and I'm trying to load the V5 disk. It goes so far
and then tells me my system has not been modified and to try again later. As you can probably tell I'm alot better at woodworking than at computers. I would appreciate any help anybody could give me.
Thankyou Pat

Pete Riddle · Post by **Pete Riddle** » Fri, Feb 16 2007, 10:20AM

If you explore the Ecab disk you will find a folder labeled Clean. In that folder is a utility called eCabResetUtility.exe if you run this Utility it will reset your eCab configuration causing the the system to believe this is a new install .This may solve your problem.

Patrick Koontz · Post by **Patrick Koontz** » Sat, Feb 17 2007, 8:53AM

Pete- it came up with check your correct security attributes on the login profile and try again. Any ideas.
Thankyou Pat

Ryan Hochgesang · Post by **Ryan Hochgesang** » Mon, Feb 19 2007, 9:37AM

Pat,

When you log into your computer, do you have Full administrative rights?

Note: FYI, questions regarding the ecab software may be better full filled by posting on the actual ecab forum. This particular forum is particularly for Thermwood CNC routers.

Thanks!

Thermwood / eCabinet Systems