Drawers in blank corner cabinet

George Davidson · Post by **George Davidson** » Fri, Mar 09 2007, 9:33AM

Has anyone put drawers in the back of a blank corner cabinet.
If so did your customer have any remarks about it.

Now that I look at the picture I think the sides of the drawers are to
high. They are 6 in high now?

greg youngken · Post by **greg youngken** » Fri, Mar 09 2007, 7:20PM

Interesting, I use a double swivel out of blind corner, then slide out of cabinet shelf system. Hope this is not a double post, my other one just seemed to vanish?

Kerry Fullington · Post by **Kerry Fullington** » Fri, Mar 09 2007, 8:38PM

George,
Wouldn't you lose the storage space in front of the drawer so they could slide out? So you wouldn't really gain anything.
Kerry

George Davidson · Post by **George Davidson** » Fri, Mar 09 2007, 8:58PM

Kerry That is right

Lamar Horton · Post by **Lamar Horton** » Fri, Mar 09 2007, 10:52PM

Unless you had a pull out in front of the back drawers and raised the back drawers up a little to clear the slides of the front drawer.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Sat, Mar 10 2007, 1:34AM

That's actuly good idea. I did a job that was resolved in similar matter.
However it was not done on eCabinets, or cnc.

George Davidson · Post by **George Davidson** » Sat, Mar 10 2007, 6:35AM

That will work
Thank You Lamar

Lamar Horton · Post by **Lamar Horton** » Sat, Mar 10 2007, 11:23AM

I have been pondering a solution for this situation for a long time and was not able to come up with simple answer. All of the pre-fabed insets for corner cabinets are outragesly priced, although I see why. I have dreamed up some pretty elaborate contraptions that, in reality, would probably not hold up over time. It wasn't until I saw your drawing that the light went on. Thanks

Thermwood / eCabinet Systems

Drawers in blank corner cabinet

Drawers in blank corner cabinet