Help

John Franzino · Post by **John Franzino** » Mon, Mar 12 2007, 4:47PM

I downloaded the 5.1 version and installed it now I cant open the program. It gives me a warning that the \"stringtab\" file is missing among others. What did I do wrong?
Also when I try to transfer files from one computer to another I cant open the files. I \"save job file as\" on my flash drive and when I try to open it on my other computer it wont open. I also copied my assemblies to my flash drive then copied it to my assembly folder on the other computer and have the same problem. It wont open any file.

John

Mike Bowers · Post by **Mike Bowers** » Mon, Mar 12 2007, 5:52PM

John I'm not sure about the string tab error, but how are you trying to open the files?

John Franzino · Post by **John Franzino** » Mon, Mar 12 2007, 6:03PM

I downloaded the patch again and was able to open the program but i try to open the job files and assembly files thru the program. ( custom layout and cabinet editor) Anything i saved from another computer will not open.
John

DanEpps · Post by **DanEpps** » Mon, Mar 12 2007, 6:28PM

Are you getting any type of error when you try to open the jobs?

John Franzino · Post by **John Franzino** » Mon, Mar 12 2007, 8:22PM

it says \" unable to open ecabinets file data \" This is on every file I try to open that I copied from another computer.

Paul Ellis · Post by **Paul Ellis** » Tue, Mar 13 2007, 3:27AM

John,
Open a Windows Explorer and navigate to the files that you have a problem with. Right click on the file and open up 'Properties'. Have a look at the attributes (at the bottom). Perhaps the 'Read-only' attribute is active. Click on it to remove the mark. Do this for all your files that you copied over. HTH

John Franzino · Post by **John Franzino** » Tue, Mar 13 2007, 1:38PM

I tried it, none of the files had the read only box checked

John

Todd Miller · Post by **Todd Miller** » Wed, Mar 14 2007, 10:41AM

John,
Can you post a few of the files you are having problems loading? I just want to see if I have the same problem on my machine.

John Franzino · Post by **John Franzino** » Wed, Mar 14 2007, 10:57AM

Todd,
I downloaded the 5.1 build 2 version and I was able to open the files after that with no problem. Thanks for everyones help on this I'm sure I'll have more questions later

right now i'm trying to load my logo image onto a plasma tv in parts editor. The image is loading on a 45 degree angle. I try to rotate it but it rotates front to back not side to side. Any ideas?
Thanks for the help

John

Todd Miller · Post by **Todd Miller** » Wed, Mar 14 2007, 11:12AM

John Franzino wrote:right now i'm trying to load my logo image onto a plasma tv in parts editor. The image is loading on a 45 degree angle. I try to rotate it but it rotates front to back not side to side. Any ideas?
Thanks for the help

John

John,
In the cabinet editor, load up a display cube and attach the image. Make sure the image application is set to stretched. This is just another way to get the same effect.

John Franzino · Post by **John Franzino** » Wed, Mar 14 2007, 1:43PM

Ahh!! Thank god for you guys and this forum, this computer would be a wheel chock for my truck by now :-/ Thanks for the help

John

Thermwood / eCabinet Systems

Help

Help

Re: