geometry creation after profile cuts?

Mark Hesketh · Post by **Mark Hesketh** » Thu, Mar 22 2007, 10:36AM

k, trying to make a shaker style mdf door... recessed panel, but with a profile around the inside of the frame. i created my profile tool, applied it to a rectangle, but now when i try to go and create the recessed panel with a pocket, i get an error message saying that i cannot create geometry on a part with a profile cut... am i doing something wrong, or do i have to create that recessed panel first?

Justin D Melhiser · Post by **Justin D Melhiser** » Thu, Mar 22 2007, 10:40AM

Mark

You will need to create the panel first before you put any profiles on the part. If you have any questions feel free to call me at 1-800-533-6901- ext. 227 Thank You

Roger Erismann · Post by **Roger Erismann** » Sat, Mar 24 2007, 9:41PM

I ran into the same message doing a similar operation....trying to lay a dadoe on a panel right next to a profiled edge...

anyhelp would be cool

Jean G Voyer · Post by **Jean G Voyer** » Sat, Mar 24 2007, 10:52PM

The profile is always the last thing you do.