One More Question

Ellen Bloomfield · Post by **Ellen Bloomfield** » Wed, May 02 2007, 5:13PM

How do you change the left and right backs on a corner cabinet to 1/4\" and leave the center back 3/4\"? Also can you move the shelf holes to the center back?

Thanks
Ellen

Kerry Fullington · Post by **Kerry Fullington** » Wed, May 02 2007, 7:33PM

Ellen,
There is not an easy way to do what you want. You would have to remove the back and add the parts back in as Display Panels and create any machining using the Part Editor.
Kerry

George Davidson · Post by **George Davidson** » Wed, May 02 2007, 10:08PM

I made a cabinet one time
I left the back all at 3/4\" and cut the right side of the back.
The panel was 29 5/16 and I cut off 29\" and it was now 5/16\"
and made up a display cube 29 5/16 x 34 1/2\" x 1/4\"
So all I had to make up was one panel and I needed a shelf so I used the top. I droped the top 12\". I could not use the shelf.
It worked for me

Thermwood / eCabinet Systems

One More Question

One More Question