error in buid 3

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, May 08 2007, 8:02AM

I updated the eCabs yesterday to build 3, and if i try to make any change to the allready exicting cabinets, eCabs shuts down and Microsoft showes a error message.

Scott G Vaal · Post by **Scott G Vaal** » Tue, May 08 2007, 8:15AM

Nemanja,

Please post a cabinet that has this problem and I will take a look at it.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, May 08 2007, 10:01AM

Scott

I am sorry, but i allready swiched back to build 2 and i changed the cabinet, so i am not shure if that cabinet is going to be helpfull, but here is the cabinet anyways.

Scott G Vaal · Post by **Scott G Vaal** » Tue, May 08 2007, 11:00AM

Nemanja Vujkovic wrote:I updated the eCabs yesterday to build 3, and if i try to make any change to the allready exicting cabinets, eCabs shuts down and Microsoft showes a error message.

You mention "cabinets". Does that mean you tried several and they gave you the same problem? What change(s) did you make?

I loaded the cabinet that you attached here and made some dimension changes and all works correctly. The only thing I got was a message about dove tail depth being thicker then the mating part for the drawer boxes (which is a valid message due to the fact that dovetail construction is set for the bottom of the back (.35 dovetail depth) to the 1/4" thick bottom). This is benign and is just warning that it will not create the dovetail construction for that connection(s). Any further information on this issue would be helpful.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, May 08 2007, 12:52PM

Scott,

The whole cabinet was made out of bleck melamine and i had to change sides, railes, upper shelf and drower fronts to be different material!
Yes, there was one more cabinet, but i deleted that one and rebuilt it!

Thermwood / eCabinet Systems

error in buid 3

error in buid 3

Re: error in buid 3