Holes Still get DROPPED!!!!

[Thom Davies]

Hey Hows it all going?

•Part editor hole placed in the corner of a blind dado (and has the exact same depth as the dado) can cause an error message “Error creating route bodies” and then it will lose part editor cuts on that part. (FIXED)


I reported this prob i had.

1 thing i want 2 point out is the the 3mm holes i was doing went right through the end.

On cabinets i still get the message come up saying Error creating route bodies.

I have posted a cab it happens on. And i cant even take an end to constanist manager ,

Thanks

Thom Davies

[Scott G Vaal]

Hey Hows it all going?

•Part editor hole placed in the corner of a blind dado (and has the exact same depth as the dado) can cause an error message “Error creating route bodies” and then it will lose part editor cuts on that part. (FIXED)


I reported this prob i had.

1 thing i want 2 point out is the the 3mm holes i was doing went right through the end.

On cabinets i still get the message come up saying Error creating route bodies.

I have posted a cab it happens on. And i cant even take an end to constanist manager ,

Thanks

Thom Davies

Thom,

Is this the cabinet you intended to attach? I do not see any part editor cuts on it. When you say "right through the end" do you mean the edge of the part or a hole going through on a right or left end of a cabinet. The cab attached here is only a cabinet back with edge banding around it. What do I need to do to reproduce your issue with this attached cabinet? Can you please give me more info on this because I unfortunately was not aware of your problem? The issue I had the programmers fix was not from you, that I know of, and it had to do with a hole interfering with a dado at the same depth as the dado. If you can help me reproduce this, I will ensure that it gets looked into.