hole patterns

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Thu, May 10 2007, 11:08AM

Does anyone have problem with hole patterns, or is it just me?
They never seem to work perfectly. They are either not deep enough, or they are just slightly misplaced.
This goes for hinge and slide patterns!

Justin Melhiser · Post by **Justin Melhiser** » Thu, May 10 2007, 2:36PM

Nemanja
Is this showing up in the software or at the machine? If its the software please send me your cabinet to cabinets@thermwood.com.

Brian Shannon · Post by **Brian Shannon** » Sat, May 12 2007, 11:39AM

Some of the \"supplied\" hole patterns are NOT deep enough. You may have to change them then save the new pattern. Also, if your partition/end is not flush with the faceframe, the holes will not be deep enough as the depth starts at the edge of the faceframe openning.

Brian