parasolid boolean subtraction error

Randy Gale · Post by **Randy Gale** » Mon, Jun 18 2007, 2:28PM

Hi,
I'm in the middle of designing a kitchen and I started getting this error on the upper cabinet doors when the program tries to add them. The first upper added the doors no problem but now it won't work on any cabinet. Any help would be greatly appreciated.

Walker T Scott · Post by **Walker T Scott** » Tue, Jun 19 2007, 6:19AM

Randy

Could you post the cabinet so we can take a look at it? What kind of doors are you using? If there Conestoga which one and what profile, bead, raise did you set as default?

Thanks
Walker

Randy Gale · Post by **Randy Gale** » Tue, Jun 19 2007, 12:52PM

I'm not sure how you post the cabinet on here. It is a Conestoga door, crp-20, fp profile, regular bead, reverse G cove. The problem seems to come from the size of the door. a door sized over 15 in. wide works just fine, but a door sized under 15 in. gives me the error.
thanks,
Randy

Walker T Scott · Post by **Walker T Scott** » Tue, Jun 19 2007, 1:25PM

Randy

There seams to be a parasolid failure when creating that door at that height with that profile. I changed the profile to b-2 profile and it worked fine so you can do that or make sure your opening height for your doors are 10 inches or higher. I have the programmers looking in to this. Sorry for the inconvenience

Thanks
walker

Randy Gale · Post by **Randy Gale** » Tue, Jun 19 2007, 4:05PM

thanks alot,
I will give that a try
Randy