Right End not nesting properly

Jeff Sallows · Post by **Jeff Sallows** » Wed, Jul 04 2007, 8:25AM

I just noticed today that a job we ran last friday ended up not doing any machining on the right ends, it strictly cut out a rectangular piece the size the gable was to be? This only happened on my upper cabinets, not my lowers, does anyone know what could be up?? I have tried just nest the one cabinet, but no go. I will attach the .hsf, we need a fix asap because this is really holding up production!

Joe Soto · Post by **Joe Soto** » Wed, Jul 04 2007, 9:05AM

Jeff, I don't know why but remove the edgebanding from the bottom of the right end, then it will nest correctly.
Joe

Mark Hesketh · Post by **Mark Hesketh** » Wed, Jul 04 2007, 9:06AM

checked it out and no matter what I do, I can't get the right gable to show any of the cuts on it. It only shows up as an outline in the nest. I have exhausted all my tricks trying to make it work and still no luck.

Unfortunately, most of the guys that might be able to fix this will all be on vacation today (4th of July). Hopefully one of the non-American forum users can figure it out if you can't wait.

Sorry I wasn't much help.

Kerry Fullington · Post by **Kerry Fullington** » Wed, Jul 04 2007, 9:28AM

Jeff,
I think they are aware of this problem and working on it.
Here is another thread talking about this.
Maybe Chris might know more.
Kerry

Jeff Sallows · Post by **Jeff Sallows** » Wed, Jul 04 2007, 9:36AM

Thanks everyone for there input , I forgot that it was July 4th, well I'm going to try to remove the edgebanding like joe said and see what happens. Thanks again!

Michael RA Greschuk · Post by **Michael RA Greschuk** » Wed, Jul 04 2007, 1:35PM

Hi Jeff, I went into global settings and reentered your global parameters did a no change on material clicked ok and resaved seemed to work hope it helps Mike

Michael RA Greschuk · Post by **Michael RA Greschuk** » Wed, Jul 04 2007, 1:46PM

Hi again Jeff, I just noticed looking at your cab after the fact that the dado was not cut on the left end of your deck.Back to the drawing board I guess

Michael RA Greschuk · Post by **Michael RA Greschuk** » Wed, Jul 04 2007, 2:11PM

Hi Jeff, I changed the percentage of the blind dado tenon setting to 51% after noticing the thickness of your material seems to work maybe

Michael RA Greschuk · Post by **Michael RA Greschuk** » Wed, Jul 04 2007, 2:22PM

Forgot the file

Walker T Scott · Post by **Walker T Scott** » Thu, Jul 05 2007, 6:38AM

Jeff

This will be fixed in the next patch.

Thanks
Walker

Chris Robinson · Post by **Chris Robinson** » Thu, Jul 05 2007, 8:20AM

Jeff, that happened on my last job except that only the base right ends were affected. Good to hear there's a fix coming down the pike. It's a real PITA to fix manually! I'm just glad I didn't use blind dado construction on that one!

Thanks Walker for the update.

Chris

Thermwood / eCabinet Systems

Right End not nesting properly

Right End not nesting properly