Lost leader in line drawing editor!!!!!

[Matt Fauller]

I was just doing another measured drawing as usual, and my leader no longer works! I am able to type text, but no line and arrow appears. I've tried everything. Please help. Attached is the job I was working on when it happened if that helps.

All help is greatly appreciated.

- Matt

[Matt Fauller]

sorry, here is the correct attachment....

[Al Navas]

Matt,

I worked with your assembly a little bit. My system was a bit sluggish when I was working with it - and THAT was quite unusual.

Soooo.... I looked at memory use:

1. Peak Commit Charge: 1.3 GB !
2. System cache: 793 MB

It seems that this large job is consuming a LOT of memory, and you might run up against max memory on your system.

My guess: The hardware you installed on the components of this assembly.

My recommendation: To get the dimensioned drawings, remove the pulls and all other hardware, and try again. Let us know if it works for you.


Al

[Matt Fauller]

Thanks for taking the time Al. However, even when working on a blank page, the leader doesn't show. The same for tables too. But they do print which is weird. I did a system restore, and used the repair utility from the installation disk, and still nothing.

I need a leader!!!!!!