Part Edit Problem?

Michael RA Greschuk · Mon, Jul 23 2007, 11:12AM

I'm finding some tops that have editing on them tends to shrink the tenon.any work around would be appreciated

Walker T Scott · Post by **Walker T Scott** » Mon, Jul 23 2007, 11:55AM

Need some more information

What build are you in?
How did you create your part editor cuts?
Were they created from closed contour?
Did you cut to a certain depth or were they cut through?
Did you flip the view before you made the cuts?

Thanks
Walker

Michael RA Greschuk · Mon, Jul 23 2007, 12:08PM

Build 4, rec tool, cut through, no flip

Walker T Scott · Post by **Walker T Scott** » Mon, Jul 23 2007, 2:19PM

Michael

I am unable to reproduce this. Are those cabinets saved in that state or can you reproduce this from scratch. I can remove the part editor cuts then re add them without the tenons shrinking.

Walker

Michael RA Greschuk · Post by **Michael RA Greschuk** » Mon, Jul 23 2007, 2:34PM

cant work on reproducing right now Iwill try later to post steps thanks for your help