Stuck using hole patterns

[Gene Davis]

I want to use the same Blum Solo slides for the top drawer in a base, as I am using for the pull out trays below.

Problem is, I have two different hardware hole patterns created. One is for the solo mounted plain, the other is for a Solo mounted on a Blum T59.3570 25mm spacer block. The block mount needs a different set of holes.

I cannot seem to get the hole pattern for the upper drawer to be different from the hole patterns for the two pullout trays below. I can switch all drawers (drawer with drawerfront above, drawerboxes without fronts below) to one pattern or the other, but I cannot seem to isolate patterns and associate them uniquely to drawers.

What's up?

[Justin Melhiser]

Gene

Can you post your cabinet or email it to me? My email is cabinets@thermwood.com

Thank you
Justin

[Zach Froble]

Gene,

If you get a chance email the cab over to me and I will take a look at it.


Zach

[Gene Davis]

For those who looked in on this thread, I found out that there is no solution, but a workaround exists.

Within a single cabinet build, only one hole pattern can be associated with a single item of hardware.

The workaround is to use a separate hardware item, not used in the cabinet build, then associate the desired hole pattern with it.

You'll have to remember this when viewing and interpreting the hardware buy list.