edit wall length

Joseph Swift · Post by **Joseph Swift** » Thu, Aug 09 2007, 12:24PM

Can anyone tell me if I can edit the wall length of an existing room? I created a kitchen based on customer supplied measurments. Now I'm doing the job and when I went to measure there were some discrepencies and I hate to start over. I have some time in the walls, cutouts etc. that I would have to recreate.

Thanks!

Joe-

DanEpps · Post by **DanEpps** » Thu, Aug 09 2007, 12:32PM

Sure...in the Wall Editor as shown in the attached image.

Joseph Swift · Post by **Joseph Swift** » Thu, Aug 09 2007, 12:50PM

Thanks Dan,

I was pretty sure it could be done, in fact I think I have done it before. I just couldn't remember and was not able to find a reference in help or the forum, I was only clicking the wall and not the end node. I did however notice that when I click on a wall and the subsiquient end node it highlights the wall built previous or former to the highlighted one depending on which end I choose, I suppose I'm doing something dumb again. I was able to work around by modifing my selection points. Sorry for being so thick and thanks much for your prompt and helpful reply.

Joe-

DanEpps · Post by **DanEpps** » Thu, Aug 09 2007, 12:58PM

No problem. If you have an adjoining wall you need to select the intersecting node and both walls. The enter the ADDITIONAL length in the Move Increment boxes--X = horizontal wall and Y = vertical. Use a negative number to shorten the wall.

Joseph Swift · Post by **Joseph Swift** » Thu, Aug 09 2007, 1:04PM

Sweet, I'm back in business. You da Man!

Joe-

Thermwood / eCabinet Systems

edit wall length

edit wall length