CN Multiple DXF causing crash

Discuss Thermwood 3-axis Machinery, Controller, and Software.

Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein

Post Reply
FredHirsch
Senior Member
Posts: 167
Joined: Tue, Oct 03 2006, 6:51PM
Location: Phoenix, AZ
Contact:
Contact FredHirsch

CN Multiple DXF causing crash

Post by FredHirsch »

I have an interesting situation where I have 4 dxf files with a small radius on the corners. If I nest them individually they work fine, but if I put them all together with a qty of 5 of each in the nest it crashes with a radius compensation message. Could someone out there try these on their control (don't cut, just graph) and see if you are getting the same error?

I have CN 5.34 installed.

Thanks,
Fred
Attachments
four_DXF.zip
(13.23 KiB) Downloaded 322 times
Fred Hirsch
Top
Daniel Vonderheide
Thermwood Team
Posts: 361
Joined: Wed, May 17 2006, 11:25AM
Location: Thermwood

Post by Daniel Vonderheide »

Fred,

Are you receiving this error while it is nesting and writing the .cnc file or when you try to run the .cnc file? Please give me a call at 1-800-221-3865 EXT 245 so we can figure out what's going on.
Top
Post Reply

Return to “Thermwood 3-Axis Machinery”