Shaker Doors In ECAB???

Michael RA Greschuk · Post by **Michael RA Greschuk** » Wed, Sep 26 2007, 5:20PM

Has anyone been able to draw a shaker door in ecab and run it on the machine

Joe Soto · Post by **Joe Soto** » Wed, Sep 26 2007, 7:24PM

Michael, are you talking about an mdf door? It can be done in the part editor using a slab door not a mdf. You can edit slabs but none of the other doors. It is much easier to use a .dxf. If you need more info just let me know.
Joe

Brian Shannon · Post by **Brian Shannon** » Thu, Sep 27 2007, 10:01PM

Yes, but not sizable.

Mike Seisser · Post by **Mike Seisser** » Sun, Sep 30 2007, 11:05PM

Is this what you're looking for? 2 1/4\" stiles & rails, 35mm cup hinge holes in the back as well.

AFAIK, this will nest. And probably take a lot of time to actually cut.

HTH.

Mike

Keith T. Ziegler · Post by **Keith T. Ziegler** » Thu, Nov 22 2007, 10:45AM

I belive Dave Hall did Hall,s Edge

Michael RA Greschuk · Thu, Nov 22 2007, 11:04AM

Thanks for all the help. I just created a slab door pocketed in part editor and ran with it. Mike