Why not stack

Gene Davis · Post by **Gene Davis** » Thu, Sep 27 2007, 12:22PM

I designed my basecabs at 23.75 depth so ends and decks would \"stack\" two-across on a 48-wide sheet.

Now I see they don't. What's up here?

Justin Melhiser · Post by **Justin Melhiser** » Thu, Sep 27 2007, 12:28PM

Gene
What do you have set for the collar in the ecabinets nest?

Thank You
Justin

Gene Davis · Post by **Gene Davis** » Thu, Sep 27 2007, 12:37PM

I just took the default of 1/2\". This is being shipped out via email as a production sharing job.

Justin Melhiser · Post by **Justin Melhiser** » Thu, Sep 27 2007, 12:38PM

Gene

Do you get the same nest with the 1/2\" taken out?

Mark Hesketh · Post by **Mark Hesketh** » Thu, Sep 27 2007, 1:18PM

keep in mind that the machine wants to run your outline tool all the way around each part. so the part generally starts a bit inside the sheet, and has the diamater of the outline tool plus a bit between each part. also depends on whether you have it set to nest horizontally or vertically.