Wall Editor

Glenn Warner · Post by **Glenn Warner** » Fri, Oct 19 2007, 5:54PM

When drawing walls the Dimension/Angle method doesn't work. I can enter the values but nothing happens when I hit enter. The x/y method works fine for both absolute and incremental. Any suggestions?

Thanks,
Glenn

Damon Nabors · Post by **Damon Nabors** » Fri, Oct 19 2007, 7:25PM

Glenn, first you enter the x/y at the start point, and then enter the x/y at the second point. Then you can go over and enter the dim / angle and it will correct itself. I just tried it and it works fine.

Hope this helps,
Damon

Damon Nabors · Post by **Damon Nabors** » Fri, Oct 19 2007, 7:29PM

Glenn, one last thought, when you are drawing the walls, RT Click and make sure you have ANGLE SNAP checked or the angle will not work.
This may be your problem.

Thanks,
Damon

Thermwood / eCabinet Systems

Wall Editor

Wall Editor