PART EDITOR

Damon Nabors · Post by **Damon Nabors** » Fri, Nov 30 2007, 10:09PM

When using the part editor on a display board or panel, do the profiled edges show up in the nest area? I have some panels I have made and when I nest them, I do not see the profile cuts.

Damon

Damon Nabors · Post by **Damon Nabors** » Fri, Nov 30 2007, 10:17PM

Let me add one thing, If I cut through the display board it shows up, the problem I am having is if I put a raised panel or something on the display board (wainscoting) the panel outline does not show up in the nest screen.

Nick M Singer · Post by **Nick M Singer** » Fri, Nov 30 2007, 11:04PM

Nope you wont see the profiles in the nest just the outlines, you will have to check the profiles in the profile modeler module

Damon Nabors · Post by **Damon Nabors** » Sat, Dec 01 2007, 9:12AM

Nick, I guess my question is, Will the profile cuts actually be cut on the machine? I will have to play around with this today.

Joe Soto · Post by **Joe Soto** » Sat, Dec 01 2007, 1:14PM

Damon Nabors wrote:Nick, I guess my question is, Will the profile cuts actually be cut on the machine? I will have to play around with this today.

Yes they will cut, if you use control nesting (you wont see it in the nest) it will use the default tooling you have set up in the profile modeler. If you want to use different tools just set a group and set it as default. Joe

Thermwood / eCabinet Systems

PART EDITOR

PART EDITOR

Re: