I think I know the answer to this (no) but incase I'm missing something - can this be done with e-cabs?
I need to make a cabinet with an inside curved arched door. I'm attaching files of what I've got so far. These are not to the scale I need just trying to see if it can be done.
I applied the curved the curved panel2.tol and I now want to apply the curved panel flat.tol and it won't let me pick an edge.
Thanks in advance.
can this be done with e-cabs
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Ray Jorgensen
- Senior Member
- Posts: 199
- Joined: Sat, Jul 29 2006, 9:11AM
- Company Name: Classic Custom Wood
- Location: NC Iowa
- Contact:
can this be done with e-cabs
- Attachments
-
- can it be done.zip
- (47.75 KiB) Downloaded 296 times
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: can this be done with e-cabs
You can probably do it...if you think "backwards."
Change the tool profile so that the profile is on the side instead of the bottom. Then run that profile from the back view of the panel and see what happens.
You might have to change the dimensions of the cube so that you are looking at it from the end and modify the first tool as well.
I posted a curved raised panel example some time ago and cannot for the life of me remember how I did it.
You might look at that post and see if it will help any.
Change the tool profile so that the profile is on the side instead of the bottom. Then run that profile from the back view of the panel and see what happens.
You might have to change the dimensions of the cube so that you are looking at it from the end and modify the first tool as well.
I posted a curved raised panel example some time ago and cannot for the life of me remember how I did it.
You might look at that post and see if it will help any.