Please see the image here.
What is the workaround? I cannot find a way in eCabs.
- 80227154910.jpg (85.36 KiB) Viewed 1624 times
Idiot-proofing assembly with asymmetrical tenons
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Gene Davis
Idiot-proofing assembly with asymmetrical tenons
I would really like the ability to make the tenons of stretcher and nailer parts asymmetrical, to enable the idiot-proofing of assembly work.
Please see the image here.
What is the workaround? I cannot find a way in eCabs.
Please see the image here.
What is the workaround? I cannot find a way in eCabs.
-
Gene Davis
Re: Idiot-proofing assembly with asymmetrical tenons
Ignore the above. Sorry. I found out how.
-
Gene Davis
Re: Idiot-proofing assembly with asymmetrical tenons
And here is a pic of the result.
A working model of a "minimum material cost" basecab that is easy and fast to assemble, with a little idiot-proofing embedded in the parts design.
The 6mm back slides into full dado slots from the bottom.
A working model of a "minimum material cost" basecab that is easy and fast to assemble, with a little idiot-proofing embedded in the parts design.
The 6mm back slides into full dado slots from the bottom.
- basecab.jpg (102.46 KiB) Viewed 1582 times
