Mastercam V9.1 problem
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
Adam Tobias
- New Member
- Posts: 3
- Joined: Fri, Feb 29 2008, 11:20AM
Mastercam V9.1 problem
Recently Mastercam v9.1 was moved onto my account from another account on the same computer, now I'm unable to "Import sheets from nesting session" and under the parts tab I can't "Save list as library" or "Load part library". I've also tried to create a new sheet and then export it to a library but all these options are grayed out... Any suggestions?
-
Ryan Hochgesang
Re: Mastercam V9.1 problem
Adam,
You may need to run the MasterCam HASP update while you are logged on to your new acct. If this doesn't work and if you have purchased your Mastercam software through Thermwood corporation, please contact program@thermwood.com for additional info.
You may need to run the MasterCam HASP update while you are logged on to your new acct. If this doesn't work and if you have purchased your Mastercam software through Thermwood corporation, please contact program@thermwood.com for additional info.
-
Adam Tobias
- New Member
- Posts: 3
- Joined: Fri, Feb 29 2008, 11:20AM
Re: Mastercam V9.1 problem
Which HASP update would I need to run? The one that was for SP2? Sorry, I'm kind of new to this.
-
Ryan Hochgesang
Re: Mastercam V9.1 problem
The HASP update comes directly from MasterCam Dealer. If you purchased MasterCam through Thermwood Corp., I will need to know you company name in order to retreive the code for you. If you did purchase your MC software through Thermwood, you can email program@thermwood.com for further details regarding this update.
