End Panels on re-sized cabinets
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Rob Perry
- Senior Member
- Posts: 103
- Joined: Sat, Feb 10 2007, 8:11PM
- Location: Qualicum Beach, Beautiful British Columbia, Canada
- Contact:
End Panels on re-sized cabinets
I always have a issue with the applied end panels on cabinets if I have to resize the cabinet. The attached pic is the latest. The cabinet was resized in highth. The applied end panels do not follow. If I delete end panels & re apply after the cabinet is resized I get what the attached pic shows. I will have to delete the cabinet & reinstall with a new one, then adding the end panel again. Anyone else had this issue?
- Attachments
-
- End Panel.jpg (59.6 KiB) Viewed 3560 times
Rob
-
Nick M Singer
- Guru Member
- Posts: 828
- Joined: Fri, Jun 17 2005, 12:23AM
- Location: South Africa
Re: End Panels on re-sized cabinets
Thanks for pointing that out Rob. I just came from site where my side panel was 100mm too short. Now I know why!
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: End Panels on re-sized cabinets
Rob, maybe you could use a cabinet side as your panel? Just uncheck all the parts you don't want. And give it a user part name.
-
Walker T Scott
Re: End Panels on re-sized cabinets
Could you attach your job when it’s in that state so we can take a look at it. At this time when you change a cabinets dimensions that have end panels the end panels will not adjust to the resize.