DRAWER BOX ERROR
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
jerry johnson
- Junior Member
- Posts: 90
- Joined: Wed, Dec 26 2007, 7:52PM
DRAWER BOX ERROR
Could someone at Thermwood look at this file and tell me what is wrong? The mortise machines properly but the tennon is too thin. Thanks in advance!
-
Larry Epplin
- Thermwood Team
- Posts: 668
- Joined: Tue, May 17 2005, 12:44PM
- Location: Thermwood
Re: DRAWER BOX ERROR
Hi Jerry. We have located the problem. Sorry for the inconvenience. We plan to have a patch available to fix the problem. I can not give a time when the patch will be available yet. We are working as diligently as possible. We appreciate your patience.
-
jerry johnson
- Junior Member
- Posts: 90
- Joined: Wed, Dec 26 2007, 7:52PM
Re: DRAWER BOX ERROR
Thanks, Larry.
-
David Hall
- eCabinets Beta Tester
- Posts: 593
- Joined: Tue, May 17 2005, 12:41PM
- Location: Stamford, CT USA
- Contact:
Re: DRAWER BOX ERROR
Same problem here.
According to the ecabs nest (and a sheet of drawer parts on its way to the dumpster)
It appears that when you change the tenons to greater than 50% thickness, the dados change in width, but most of the tenons remain at 50%.
50% thickness seems like it would work.
Regards,
Dave
According to the ecabs nest (and a sheet of drawer parts on its way to the dumpster)
It appears that when you change the tenons to greater than 50% thickness, the dados change in width, but most of the tenons remain at 50%.
50% thickness seems like it would work.
Regards,
Dave
