6 in Fluted column

Greg Smith · Post by **Greg Smith** » Wed, Apr 12 2006, 3:32PM

In case anyone has a need for this.

6\" square to start, .25 offset and -6.25\" plunge
flip and repeat for full column

Al dedenus · Post by **Al dedenus** » Thu, Jul 17 2008, 2:25AM

How do you flip it to do the other side????

Greg Smith · Post by **Greg Smith** » Thu, Jul 17 2008, 7:04AM

Its been a while so I had to go and try it and see what I did. The trick is where you click on the part when making the profile cut. Click on the lower left side for the first cut and then the upper part of the right side for the second cut, and it should work for you. Where you click is the start of the cut so you can change the direction of travel by changing the start. Hope it helps.

Al dedenus · Post by **Al dedenus** » Thu, Jul 17 2008, 8:48PM

Thanks Greg worked a treat

Thermwood / eCabinet Systems

6 in Fluted column

6 in Fluted column

Re: 6 in Fluted column

Re: 6 in Fluted column

Re: 6 in Fluted column