Installing the sink

[Bob Segneri]

Hello everyone. I am attempting to design and bid my first kitchen with ecaqbinets and not doing to bad. Ran into a major snag trying to place the sink. I did a cut through in the counter top but can't seem to get the sink off the floor in the middle of the kitchen. The other snag is I can't seem to get the door and drawer fronts on the customer view.
Thanks

[Wally Schneeberger]

Bob -- Highlite the sink and use the SHIFT key and up ARROW at the same time. As for the D & Ds make sure that they aren't checked to HIDE them.

[Rick Palechuk]

Hey Bob, go to Show/Hide and see if you have Doors and Drawer Fronts checked.

[Dennis Englert]

Associate the sink to the wall, then when you go to the elevation view you can move it up to the desired height either by entering positional information on the left. dragging it to location or using move increment methods.

The key to selecting the sink is that it must be associated to the wall.