Dado for partition

[Gary Puckett]

Does anybody know how to put a full dado in the deck and top for a partition?

I have went to the partition setting and told it full dado top and bottom and it did nothing.

Gary

[Kerry Fullington]

Gary,
If it is an existing partition, highlight it then go to construction settings and change the parameters to full dado and click OK. The cabinet will re-generate with the full dado.

Kerry

[Gary Puckett]

Kerry,


I did that 3 times and all I get is the system acks like it is making the change but nothing happens.Had to go to the shelf partition editor delete the partition and reinstall it now it's ok.


Gary

[Damon Nabors]

Does anybody know how to put a full dado in the deck and top for a partition?

Gary

I normally use the Thermwood to route full dados on a big job, but if it is just a small job, a jig and a small hand held will work fine.

[Justin Melhiser]

Gary
Do you still have this cabinet file where the partition will not change? If you do, please email it to me. Where you in the shelf partition editor or in the main when trying to make the changes?

[Gary Puckett]

Justin I did get it to work have to do it at the shelf /partition editor the go to the cabinet editor then it does it.

Over the week end I got an external hard drive and openned up over 10 GB on my computer

Gary