Adding Doors

[John J. Desmond]

Can anyone tell me how to add doors to a cabinet that has pullout drawers?

ftoc cabinet.jpg

Thanks,
John D.

[Leo Graywacz]

You need to add the drawers in the DBX editor. You cannot use the door/drawer editor area. Then you can add doors just like you normally would.

[Damon Nabors]

Or you could show the doors open by adding the doors manually with the drawers pulled out.

Damon

[John J. Desmond]

Leo,
Thanks, that worked well. It is funny you should answer this post. This cabinet is for a job for my brother Leo.

Damon,
If I were to do your way would the doors show up on the cut list?

John Desmond

[Damon Nabors]

Yes

[John J. Desmond]

Damon,

How do you get such a good clean look to your cabinets. I really like the way it looked in the posted picture.

John Desmond

[Damon Nabors]

What exactly are you talking about. This was just a basic cabinet with some pull outs. Give me some more details or post a picture of your layout and maybe I can see what your looking for. I am sure we can get you up to speed in a few simple steps.

you might even try changing some of your textures.

[John J. Desmond]

Damon,

I am talking about texture. I will try to change it. I am thinking that I am not sure how to do that. I will attempt it.

John

[Damon Nabors]

I would change the textures on your sheet goods, If they have a lot of grain, they seem to pop out at you too much. Go for a little more subtle grain pattern.

[John J. Desmond]

Damon,
aaaarrrrrhhhhh!!!! How do you change texture? I can change the pictures but everything is just as grainy. I think I am missing something. In the picture you posted on this post, is it part of ecabs or is it something you got elsewhere?

John

[Damon Nabors]

Go into ecabinets>Settings/preferences>Define Stock material>sheet type>sheet stock>

Then chose your sheet good that you want to change.

Click select image> scroll down to Hard maple or imported Images and you can choose an image that you like.