Something is off with outline cut

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Mon, Mar 02 2009, 2:50PM

I am cutting a cabinet and outline is way off. It is not rectracting to the specified hight.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Mon, Mar 02 2009, 3:26PM

I think that i figured it out. I looks like that when the material ticknes and max penetration are the same value ( in my case .8" for both) the cnc does not rectract to the specifide hight. Can anyone verify this?
Thank You.

Nemanja

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, Mar 03 2009, 12:13PM

Hi everyone,
I was just wondering what was figured on the problem I had. Am i correct in my asamption?

Daniel Vonderheide · Post by **Daniel Vonderheide** » Tue, Mar 03 2009, 12:26PM

You are correct. There is an issue with depth cuts right now. If your material thickness is greater than or equal to your max penetration, it does not finish the operation properly. The software engineers know of this issue so it should be fixed in the next release of Control Nesting.

Nemanja Vujkovic · Post by **Nemanja Vujkovic** » Tue, Mar 03 2009, 2:27PM

Thank you Daniel.

Nemanja

Thermwood / eCabinet Systems

Something is off with outline cut

Something is off with outline cut

Re: Something is off with outline cut

Re: Something is off with outline cut

Re: Something is off with outline cut

Re: Something is off with outline cut