Creating a new door

Sergio Fetter · Post by **Sergio Fetter** » Thu, Mar 12 2009, 2:21PM

Hello everyone,

Is there a way that I can create a door and have applied molding to it. I am trying to get a door with rope molding around the door.
Can anyone give a suggestion.

Thanks!

DanEpps · Post by **DanEpps** » Thu, Mar 12 2009, 2:58PM

The only way I know of is to add the door then manually add the molding. The only thing is that you will have to overlap the ends since the automatic miter will be in the wrong orientation.

Sergio Fetter · Post by **Sergio Fetter** » Thu, Mar 12 2009, 3:09PM

Dan,
Thanks for the answer.
The only problem that I have with that is... If I have 20 doors, I will have to do one by one???

DanEpps · Post by **DanEpps** » Thu, Mar 12 2009, 3:17PM

Yup. Someone else may know of an easier method but I don't.

Kerry Fullington · Post by **Kerry Fullington** » Thu, Mar 12 2009, 5:07PM

Sergio,

Use the Conestoga Saxony Door from standard doors. It already has the rope molding on it.

Kerry

DanEpps · Post by **DanEpps** » Thu, Mar 12 2009, 6:44PM

I knew someone would have a better way.

Thermwood / eCabinet Systems

Creating a new door

Creating a new door

Re: Creating a new door

Re: Creating a new door

Re: Creating a new door

Re: Creating a new door

Re: Creating a new door