Unable to Edgeband Part

Nat Wheatley · Post by **Nat Wheatley** » Sat, Apr 18 2009, 7:14PM

I'm working on a frameless cabinet , with no back. In the edgebanding editor, for the deck, I'm only given the option to select the type of edgebanding for the back edge. How do I configure this part to have edgebanding on the front edge as well?

Damon Nabors · Post by **Damon Nabors** » Sat, Apr 18 2009, 7:22PM

can you post the cabinet so we can take a look at it?

Nat Wheatley · Post by **Nat Wheatley** » Sat, Apr 18 2009, 7:25PM

Hopefully this works...

Nat Wheatley · Post by **Nat Wheatley** » Sat, Apr 18 2009, 8:02PM

When I nest that same cabinet, it doesn't seem to subtract for the edgebanding on the front edge of the top...

Damon Nabors · Post by **Damon Nabors** » Sat, Apr 18 2009, 8:57PM

Here is your cabinet with edgebanding. You need to open the construction settings and set the deck , front edge to Butt . You will notice the area is blank.

Nat Wheatley · Post by **Nat Wheatley** » Sat, Apr 18 2009, 9:06PM

Damon, thanks for the fix. -Nat

Damon Nabors · Post by **Damon Nabors** » Sat, Apr 18 2009, 10:33PM

No problem, Glad I was able to help.

Thermwood / eCabinet Systems

Unable to Edgeband Part

Unable to Edgeband Part

Re: Unable to Edgeband Part

Re: Unable to Edgeband Part

Re: Unable to Edgeband Part

Re: Unable to Edgeband Part

Re: Unable to Edgeband Part

Re: Unable to Edgeband Part