Unable to Delete Shape in Part Editor

[Nat Wheatley]

I created the small circle (below) in PE and wasn't able to delete it either in 'standard' or contour mode.

Error1B.PNG (88.69 KiB) Viewed 9778 times

[Jon Kenworthy]

You can right click with this cabinet in the cabinet editor and select Remove Part Editor Cuts either from selected part or the entire cabinet.

[Nat Wheatley]

Thanks, Jon, I eventually did come across that button. If it's not there already, it might make sense for that option to be available in PE as well.

[JohnLashuay]

Thanks, Jon, I eventually did come across that button. If it's not there already, it might make sense for that option to be available in PE as well.

Nat, it is available in the PE. You can remove individual geometry cuts by clicking on the pencil and choosing option "Geometry Cut" then hover over the cut you wish to remove and it will be highlighted. Left click it and only that cut will be removed.

-John

[Nat Wheatley]

John, I just tried that and it works great. Not clear on why I didn't try to use it before. Thanks.

[JohnLashuay]

Not clear on why I didn't try to use it before.

I find myself wondering the same thing!!

[DanEpps]

Not clear on why I didn't try to use it before.

I find myself wondering the same thing!!

COFFEE!!! Must have coffee...