Moving KD/ Hole pattern !

[Stephen Tinkler]

Is there anyway of moving KD/RTA Hole pattern .5 to 1mm inward, we are useing Hafele RAFIX HF-26310705 and think it is a bit close to the edge?

Thanks Stephen

[DanEpps]

You can set the location in Construction Settings for the part. With Construction Settings open, click the <part> Construction Parameter button at the bottom of the dialog. You have to do this for each part you wish to change and it is only for newly added holes, so you will have to remove existing holes first.

[Stephen Tinkler]

Dan

The Rafix housing is slightly proud of the edge so we need to move it inward so that when it is tighened up the joint is flush, we just need to move it away from the edge a fraction plus the hole is a little bit tight for the fitting and will need to make it slightly larger.

Cheers Stephen

[DanEpps]

Then you need to edit the hole pattern and set the depth correctly.

[Stephen Tinkler]

Yes, But how will I go about doing that?
Chees Stephen

[DanEpps]

Use the Hardware Hole Editor. After starting the HHE, click the Open/Add button and find the hole pattern you want to edit. When you have the pattern loaded, double-click on the pattern and it will turn red. Now you can set the depth.

HHE.jpg (68.39 KiB) Viewed 6189 times

HHE2.jpg (51.36 KiB) Viewed 6188 times

[Stephen Tinkler]

Hi Dan sorted that out
Thanks Stephen