Knob/Pull Hole Pattern

Nat Wheatley · Post by **Nat Wheatley** » Tue, Jun 23 2009, 5:39PM

Is there a way to associate a hole pattern with a knob or pull? I did a search of the archived posts a while back and didn't come across a method, but wanted to double check here also. Thanks.

DanEpps · Post by **DanEpps** » Wed, Jun 24 2009, 5:44AM

Not that I know of.

Kerry Fullington · Post by **Kerry Fullington** » Wed, Jun 24 2009, 6:51AM

Nat,

I think that has been on the wish list for added features for a while but not implemented yet.

Kerry

Nat Wheatley · Post by **Nat Wheatley** » Wed, Jun 24 2009, 7:01AM

Thanks. It would be a nice feature, and save several steps. Hopefully they will add it.

Nat

Kerry Fullington · Post by **Kerry Fullington** » Wed, Jun 24 2009, 7:11AM

Nat,

Be sure to go to Communications then Feedback and send this in to the programmers as an added feature request. Don't assume that Thermwood will see your request here. The more requests for a feature gives it a better chance to be added. (Squeaky wheel)

Kerry

Nat Wheatley · Post by **Nat Wheatley** » Wed, Jun 24 2009, 12:04PM

Hadn't even seen the 'Communications' tab until now. Thanks!

George Davidson · Post by **George Davidson** » Wed, Jun 24 2009, 8:23PM

Would this work for anyone

I made a DXF with holes lay ed out every 1/4" on the drawer up to 6" off the center
I started out with a base cab 24 x 34.5 x 24 with slad drawer I set my hole pattern to what I wanted. Then I can resize
the cabinet to the size I want to use.The holes stay in the center of any cabinet size

Try it

Thermwood / eCabinet Systems

Knob/Pull Hole Pattern

Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern

Re: Knob/Pull Hole Pattern