The standard slab doors is not showing up right in the cut list. Is there a way to change this to get it right. Can you add edgebanding to slab doors?
Thanks
Chris Harmon
http://www.azurecabinets.com
SlaB Doors
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Chris Harmon
- Junior Member
- Posts: 39
- Joined: Sat, Apr 04 2009, 10:20PM
- Company Name: Azure Cabinets
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: SlaB Doors
The standard Slab Door has edgebanding, which the thickness is deducted from the size of the door. You can create edgebanding of 0" thickness for your doors to show on your list "as per".
-
Chris Harmon
- Junior Member
- Posts: 39
- Joined: Sat, Apr 04 2009, 10:20PM
- Company Name: Azure Cabinets
-
Rick Palechuk
- Wizard Member
- Posts: 1896
- Joined: Wed, May 18 2005, 7:54PM
- Company Name: Milltech Millworks Ltd.
- Country: CANADA
- Location: Edmonton, Alberta
- Contact:
Re: SlaB Doors
You can create edgebanding in Settings/Preferences> Define Stock Materials, then select Stock Type> Banding Stock.
-
Chris Harmon
- Junior Member
- Posts: 39
- Joined: Sat, Apr 04 2009, 10:20PM
- Company Name: Azure Cabinets
Re: SlaB Doors
Thanks Rick,
I figured it out. I went to define doors and built slab doors with the edge banding thickness that I needed.
Chris Harmon
http://www.azurecabinets.com
I figured it out. I went to define doors and built slab doors with the edge banding thickness that I needed.
Chris Harmon
http://www.azurecabinets.com
