I am trying to modify an open corner cabinet fron the 32mm system library to my construction settings. I can't seem to get rid of drill holes in the back of the cabinet. I cleared all the defaults for the cabinet assuming that they were connector holes.
Any suggestions?
Lorin
removing holes fron library cabinet
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
Lorin Ylioja
- Junior Member
- Posts: 39
- Joined: Tue, Apr 14 2009, 10:25PM
- Company Name: Heritage Woodcraft
- Location: Conquest Saskatchewan
-
Kerry Fullington
- Wizard Member
- Posts: 4735
- Joined: Mon, May 09 2005, 7:33PM
- Company Name: Double E Cabinets
- Country: UNITED STATES
- Location: Amarillo, TX
Re: removing holes fron library cabinet
Lorin,
Highlight the part by clicking it and then right click and choose Remove Part Editor Cuts/from selected part.
Kerry
Highlight the part by clicking it and then right click and choose Remove Part Editor Cuts/from selected part.
Kerry