I am attaching (hopefully) a sketch of what I need to draw. Angled storage under a staircase with cropped doors, etc. I can't figure out an easy way to do this other than build separate cabinets and using part editor, changing each side, back and door to get the angle I need. Is there an easy way to angle the top of a cabinet and get the doors to follow, etc? Could I make a 96" wide cabient with multiple doors?
I know some of you will just do this in seconds but I want to know HOW to do it as much as I want to have it done.
Thanks for your help.
Rob
Need help drawing
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal, Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
Need help drawing
- Attachments
-
- Stair storage.pdf
- (5.27 MiB) Downloaded 294 times
-
DanEpps
- Wizard Member
- Posts: 5852
- Joined: Thu, Jul 28 2005, 10:18AM
- Company Name: Dan Epps
- Country: UNITED STATES
- Location: Rocky Face GA
Re: Need help drawing
You can make a single cabinet then modify the back in the Part Editor. You will have to make the doors in the Part Editor also and the top will be a Display Panel of the appropriate size, rotated to the correct angle.
The good news is that you can use top offsets for the left end and any partitions.
The good news is that you can use top offsets for the left end and any partitions.