Size of Blind Dado on Stretcher
Moderators: Jason Susnjara, Larry Epplin, Clint Buechlein, Scott G Vaal
-
- Junior Member
- Posts: 43
- Joined: Thu, Mar 27 2008, 6:00PM
- Company Name: darrells Carpenter Shop
- Location: Marana, AZ
Size of Blind Dado on Stretcher
Any ideas why the blind dado on the stretcher of the attached cabinet doesn't extend to within an inch of the bottom?
- Attachments
-
- Display cabinet.jpg (55.96 KiB) Viewed 4477 times
-
- Junior Member
- Posts: 61
- Joined: Mon, Nov 30 2009, 3:51PM
- Company Name: Jim Carter Corp.
Re: Size of Blind Dado on Stretcher
Jon
I think the strecher was added in the up down orentation and then rotated to the front to back orientatio, but upside down. This is why the top/bottom tenion switch was working backwards.
In the upside down posision the front inset onthe sides were affecting the dados. I deleted the strecher and added a new one in the front to back orentation and it worked just fine.
JIm
I think the strecher was added in the up down orentation and then rotated to the front to back orientatio, but upside down. This is why the top/bottom tenion switch was working backwards.
In the upside down posision the front inset onthe sides were affecting the dados. I deleted the strecher and added a new one in the front to back orentation and it worked just fine.
JIm
-
- Junior Member
- Posts: 43
- Joined: Thu, Mar 27 2008, 6:00PM
- Company Name: darrells Carpenter Shop
- Location: Marana, AZ
Re: Size of Blind Dado on Stretcher
Thanks, Jim.
Jon
Jon