Openings Not Selecting Correctly in Door Editor

Nat Wheatley · Post by **Nat Wheatley** » Sat, Jan 16 2010, 10:42AM

Take the attached cabinet into the door editor, remove the door and try to select the opening where the door was. Clicking toward the top of the opening doesn't select anything. Clicking toward the bottom of the opening, selects part of the opening.

: A.PNG (52.44 KiB) Viewed 2273 times

Nat Wheatley · Post by **Nat Wheatley** » Sat, Jan 16 2010, 10:45AM

I added a door (that appeared displaced), deleted it, and was able to select the opening correctly. Not clear on why the issue would occur originally, though.

Nat Wheatley · Post by **Nat Wheatley** » Sat, Jan 16 2010, 10:47AM

Now when I add a 605mm tall door, it creates a door the full height of the cabinet, covering the drawer front...

Thermwood / eCabinet Systems

Openings Not Selecting Correctly in Door Editor

Openings Not Selecting Correctly in Door Editor

Re: Openings Not Selecting Correctly in Door Editor

Re: Openings Not Selecting Correctly in Door Editor