When we try to use an off fall, for some reason when we do "accept sheet" it will show a second of the same off fall. Then it freezes up. When we don't click the "accept sheet" button it doesn't freeze up and it works. Is anyone else having this happen?
-John
CN Freezing up when using off falls
Moderators: Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein, Mike Iubelt, Jason Susnjara, Larry Epplin, Clint Buechlein
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
-
Daniel Vonderheide
- Thermwood Team
- Posts: 361
- Joined: Wed, May 17 2006, 11:25AM
- Location: Thermwood
Re: CN Freezing up when using off falls
What version of Control Nesting are you using? You can find this in the top left corner on the screens title bar.
-
JohnLashuay
- Guru Member
- Posts: 645
- Joined: Mon, Nov 20 2006, 3:39PM
- Company Name: Rylex Custom Cabinetry-Close
- Country: UNITED STATES
- Location: Pine Island, New York
- Contact:
Re: CN Freezing up when using off falls
Hi Daniel!
We are using CN 5.49. I spoke with Scott Vaal about this and the conclusion we came to is that when scanning in a bar code for an off fall, it is already accepting the sheet so there is no need to click the "accept sheet" button. Since we stopped accepting the sheet the second time it hasn't been an issue.
Thanks,
-John
We are using CN 5.49. I spoke with Scott Vaal about this and the conclusion we came to is that when scanning in a bar code for an off fall, it is already accepting the sheet so there is no need to click the "accept sheet" button. Since we stopped accepting the sheet the second time it hasn't been an issue.
Thanks,
-John