Material Thickness Question

Nat Wheatley · Post by **Nat Wheatley** » Thu, Feb 25 2010, 6:52PM

When I create a TWD file and choose to change a material thickness, it appears that the ESJ file retains the new material thickness. When I go to open the ESJ file, after the fact, it's treating the material whose thickness has been changed, as a new material, that needs to be added. Is this how it's supposed to work? I've only recently used this option to change the material thickness. Thanks.

Rick Deskins · Post by **Rick Deskins** » Thu, Feb 25 2010, 7:31PM

This was a bug reported in V6 Build1. V6 Build2 should prevent that from happening.

Nat Wheatley · Post by **Nat Wheatley** » Thu, Feb 25 2010, 7:44PM

Rick,

It's still happening in Build 2.

Nat

Josh Rayburn · Post by **Josh Rayburn** » Fri, Feb 26 2010, 10:04AM

Same here. I've attempted to send some files to Ryan to look into this.
jnr

Thermwood / eCabinet Systems

Material Thickness Question

Material Thickness Question

Re: Material Thickness Question

Re: Material Thickness Question

Re: Material Thickness Question