Measure tool error?

Terry Davis · Post by **Terry Davis** » Mon, Apr 19 2010, 1:28PM

When I use "Maintenance Tool Unload" to return a bit to the typewriter head to take out a dull bit and use "Maintenance Tool Load to return a new bit to the spindle I'm getting an error when I go to measure that bit. It says " Invalid AFL statement, maybe files may be open" I read it twice to make sure I was reading it right! Then I have to exit Supercontrol and restart it then I can measure the bit as usual without the error.

Carl Jones · Post by **Carl Jones** » Wed, Apr 21 2010, 2:37PM

Hello Terry, What version of THM software is on your control currently? Try pressing "Ctrl" and "V", it should pop up on the screen. Thanks

Terry Davis · Post by **Terry Davis** » Wed, Apr 21 2010, 4:00PM

Carl,
ver 7.4.5.10 installed about 2 months ago.

Carl Jones · Post by **Carl Jones** » Thu, Apr 22 2010, 6:36AM

Thanks Terry, I will get back to you asap on this.

Carl Jones · Post by **Carl Jones** » Thu, Apr 22 2010, 8:17AM

Hello Terry, what is a good number that I can reach you? I will call you. Thanks

Terry Davis · Post by **Terry Davis** » Thu, Apr 22 2010, 10:04AM

Hi Carl,
(724) 925-9100

Thermwood / eCabinet Systems

Measure tool error?

Measure tool error?

Re: Measure tool error?

Re: Measure tool error?

Re: Measure tool error?

Re: Measure tool error?

Re: Measure tool error?