clipped corner cabinet

Ray Jorgensen · Post by **Ray Jorgensen** » Thu, May 13 2010, 12:23PM

Does anyone have a clipped corner cabinet that they would like to share? I'm having a little problem getting my head around how to do these.

Thanks

JohnLashuay · Post by **JohnLashuay** » Thu, May 13 2010, 1:44PM

Ray, is this what you are looking for?

Ray Jorgensen · Post by **Ray Jorgensen** » Thu, May 13 2010, 2:26PM

Thanks John I should have used a better description. I need to angle "clip" the front corner of a base cab on the end of a run. It will be clipped on the right hand side. Hope that is clearer.

Kenneth Rychlik · Post by **Kenneth Rychlik** » Thu, May 13 2010, 6:23PM

Is this getting closer?

Kenneth

Ray Jorgensen · Post by **Ray Jorgensen** » Fri, May 14 2010, 6:26AM

Nope Kenneth, I need a 20" wide 24" deep base with the right side measuring 20".. Now clip the corner at a 45. That corner will be a "finished" piece with the door to the left of that. If I keep at this maybe I'll make myself clear!!! Thanks

Dennis Englert · Post by **Dennis Englert** » Fri, May 14 2010, 7:28AM

Ray,
On the 20" side, use a 4" inset on the front to adjust. Chamfer the corner of that part 45 degrees with the Part Editor. You might also restrict it with the Constraint Manager. Install a door, but increase the reveal on the chamferred corner to adjust for the placment of the door. A display panel or display board would have to be manually placed on the chamfered corner and associated with the cabinet to save it.

If this is a face frame cabinet, then you'll need to play with negative scribes on the chamfered corner. There's a little more math, but all doable.

Dennis

Dennis Englert · Post by **Dennis Englert** » Fri, May 14 2010, 7:29AM

Correction: Chamfer the corner of the top, deck and any shelves, not the end panel.

Sorry about that.

Dennis

Gary Puckett · Post by **Gary Puckett** » Fri, May 14 2010, 7:32AM

Ray,

Can you draw a overhead view of the cabinet to show us.

Gary

JohnLashuay · Post by **JohnLashuay** » Fri, May 14 2010, 8:45AM

How about this one? It is a corner cabinet that would need more modification.

-John

Ray Jorgensen · Post by **Ray Jorgensen** » Fri, May 14 2010, 9:08AM

John,

That's what I was looking for!!!! From there I can see how you did it a proceed. Thanks

Dan Calvert · Post by **Dan Calvert** » Fri, May 14 2010, 10:14AM

Ray,

Here is another style of clip corner cabinet.

George Davidson · Post by **George Davidson** » Fri, May 14 2010, 12:50PM

This is all you get on Friday Ray

It is 3 Cabinets

Thermwood / eCabinet Systems

clipped corner cabinet

clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet

Re: clipped corner cabinet