Gussets?

Nat Wheatley · Post by **Nat Wheatley** » Sun, Sep 05 2010, 1:15PM

I have a number of platforms to make that need angled gussets at the top and bottom. Is there a way to do this in Ecabinets? Not the end of the world if I need to do them as separate pieces, added to the batch list, but I wanted to see if there was a better way first. Sketch attached of top view of platform, hatch patterns represent the gussets. Thanks.

Rick Palechuk · Post by **Rick Palechuk** » Sun, Sep 05 2010, 4:40PM

Do you just need the part? If so take a panel to the Part Editor. Or do you need the joinery too?

Rick Palechuk · Post by **Rick Palechuk** » Sun, Sep 05 2010, 5:56PM

Take a look at this Nat, and see if it would work for you. It is re-sizable, and will nest.

Nat Wheatley · Post by **Nat Wheatley** » Mon, Sep 06 2010, 5:39AM

Rick,

That's what I was looking for, thanks very much.

Nat

Thermwood / eCabinet Systems

Gussets?

Gussets?

Re: Gussets?

Re: Gussets?

Re: Gussets?