Non Manifold body

[Leo Graywacz]

I am trying to make a panel that is curved using the contour editor, some lines and an asymmetrical cutter. I keep getting this

Driving me nuts

[Kerry Fullington]

Leo,

Try reversing the direction of the cut.
Make sure your cutting depth isn't too deep for your material.
Which Asymmetrical cutter are you using?

[Leo Graywacz]

I tried all different depths. Of course I tried both ways. It was the #3 asymmetrical cutter, the standard panel. I even tried a bunch of different router bits including a simple straight bit. I changed my material to a 2" thick cube. Just about always the same error. Other times it was a different error.

If I did a partial wrap or a single line cut it would work. But as soon as the curve was involved it would give the error.

[Kerry Fullington]

Leo,

Are you using the latest build released yesterday? I am not seeing the problems with it.

[Leo Graywacz]

I wasn't then I downloaded it and installed and I had the same issue. I rebuilt the panel several times, restarted the software, tried boards and cubes, different depths, different cutters all ended up in errors. The only times I got anything to work right was when the panel was on the wrong side of the line. And of course, that does me no good.

[Kerry Fullington]

Leo,

Save your part with the geometry as an assembly and post it.

Kerry

[Kerry Fullington]

Leo,

I think your panels may be too close together in the center for the assymetrical cutter to work.

Kerry

[Leo Graywacz]

That was it Kerry, too close together. Not sure why it wouldn't let me cut the first panel. I could understand it not letting me cut the second.

Thanks Kerry.