45 Degree corner cabinets

Tim Heese · Post by **Tim Heese** » Tue, Oct 05 2010, 10:06AM

Hi, when I have a angle corner cabinet in the cabinet editor and size right and left ends to 12", then hold my mouse over the parts they are 12.625.
I then have to adjust the front inset by .625 and also the top, bot, and shelf front insets to aprox .44. Any ideas?
Thanks
Tim

Josh Rayburn · Post by **Josh Rayburn** » Tue, Oct 05 2010, 11:29AM

Hi Tim,
This is intentional to consider the amount of material that will be mitered off which assumes that you will miter the left and right end at 45 degrees. You have to use those insets or decrease the size of the cabinet to account for the "automath" feature if you're not going to miter the front edges.
This feature will automatically add whatever the material thickness is to the front edge - so if you've got .75" sides, it would add .75" to the depth instead of .625 that you're using now.
Hope this helps,
jnr

Tim Heese · Post by **Tim Heese** » Tue, Oct 05 2010, 11:43AM

Thanks Josh

Forrest Chapman · Post by **Forrest Chapman** » Tue, Oct 05 2010, 11:48AM

It would be nice to have a choice.

Forrest

Tim Heese · Post by **Tim Heese** » Tue, Oct 05 2010, 11:54AM

If I remember correctly, way back in V3,4,and 5 this was not the case, a 12" side was a 12" side, but, I am old and probably don"t remember too well.
Tim

Josh Rayburn · Post by **Josh Rayburn** » Tue, Oct 05 2010, 1:08PM

I agree Forrest - it sure would be nice to have the option!
jnr

Michael S Murray · Post by **Michael S Murray** » Tue, Oct 05 2010, 3:45PM

ya, its a pain, I honestly dont know any one who would miter that, not on frameless anyway....

Thermwood / eCabinet Systems

45 Degree corner cabinets

45 Degree corner cabinets

Re: 45 Degree corner cabinets

Re: 45 Degree corner cabinets

Re: 45 Degree corner cabinets

Re: 45 Degree corner cabinets

Re: 45 Degree corner cabinets

Re: 45 Degree corner cabinets